Included in Hardware Kit:
- One, 3/4in magnetic snap
- One, zipper end
- One label
Included in Hardware Kit:
- One, 3/4in magnetic snap
- One, zipper end
- One label
A very sturdy, high quality press lock. No key required, this is a non-locking press lock, thumb catch, tongue lock. Install this little lock by sliding the press part onto a finished bag or wallet flap and screwing through the back to secure - USE GLUE for security! Place the backing plate prongs (the catch part) through your fabric and secure over a washer. Add a layer of stabilizer in between for strength. Easy!
Measurements: 1-1/8in (28 mm) wide x 1-1/2in (38 mm) high The groove that slides onto the bag/wallet flap has 3/16in (4mm) opening, and the lock sits about 1/2in (12 mm) high above the bag surface.
A very sturdy, high quality press lock. No key required, this is a non-locking press lock, thumb catch, tongue lock. Install this little lock by sliding the press part onto a finished bag or wallet flap and screwing through the back to secure - USE GLUE for security! Place the backing plate prongs (the catch part) through your fabric and secure over a washer. Add a layer of stabilizer in between for strength. Easy!
Measurements: 1-1/8in (28 mm) wide x 1-1/2in (38 mm) high The groove that slides onto the bag/wallet flap has 3/16in (4mm) opening, and the lock sits about 1/2in (12 mm) high above the bag surface.
A very sturdy, high quality press lock. No key required, this is a non-locking press lock, thumb catch, tongue lock. Install this little lock by sliding the press part onto a finished bag or wallet flap and screwing through the back to secure - USE GLUE for security! Place the backing plate prongs (the catch part) through your fabric and secure over a washer. Add a layer of stabilizer in between for strength. Easy!
Measurements: 1-1/8in (28 mm) wide x 1-1/2in (38 mm) high The groove that slides onto the bag/wallet flap has 3/16in (4mm) opening, and the lock sits about 1/2in (12 mm) high above the bag surface.
A very sturdy, high quality press lock. No key required, this is a non-locking press lock, thumb catch, tongue lock. Install this little lock by sliding the press part onto a finished bag or wallet flap and screwing through the back to secure - USE GLUE for security! Place the backing plate prongs (the catch part) through your fabric and secure over a washer. Add a layer of stabilizer in between for strength. Easy!
Measurements: 1-1/8in (28 mm) wide x 1-1/2in (38 mm) high The groove that slides onto the bag/wallet flap has 3/16in (4mm) opening, and the lock sits about 1/2in (12 mm) high above the bag surface.
Bag clip for use with all hand and travel bags etc. Strong and easy to fit.
Metal D Rings - 20mm
D Rings. Suitable for belts, straps and garment accessories.
