These quality locks are assembled a little differently than others. The front hole plate is put together with two screws (included), and the turn part has prongs that enclose over a washer that is hidden between the lining and exterior or your bag. These are professional grade quality. Installation instructions included. Measurements: 1-3/8in x 3/4in
These quality locks are assembled a little differently than others. The front hole plate is put together with two screws (included), and the turn part has prongs that enclose over a washer that is hidden between the lining and exterior or your bag. These are professional grade quality. Installation instructions included. Measurements: 1-3/8in x 3/4in
Included in Hardware Kit:
- One, 3/4in magnetic snap
- One, zipper end
- One label
Included in Hardware Kit:
- One, 3/4in magnetic snap
- One, zipper end
- One label
These professional-looking Dome Bag Feet are perfect for purses, backpacks, and handbags! Purse feet help prevent the bottom of your bag from getting dirty. Also, they add stability to the bottom of your bag. These bag feet measure 1/2in in diameter. You will receive a set of 4 purse feet including washers.
A very sturdy, high quality press lock. No key required, this is a non-locking press lock, thumb catch, tongue lock. Install this little lock by sliding the press part onto a finished bag or wallet flap and screwing through the back to secure - USE GLUE for security! Place the backing plate prongs (the catch part) through your fabric and secure over a washer. Add a layer of stabilizer in between for strength. Easy!
Measurements: 1-1/8in (28 mm) wide x 1-1/2in (38 mm) high The groove that slides onto the bag/wallet flap has 3/16in (4mm) opening, and the lock sits about 1/2in (12 mm) high above the bag surface.
A very sturdy, high quality press lock. No key required, this is a non-locking press lock, thumb catch, tongue lock. Install this little lock by sliding the press part onto a finished bag or wallet flap and screwing through the back to secure - USE GLUE for security! Place the backing plate prongs (the catch part) through your fabric and secure over a washer. Add a layer of stabilizer in between for strength. Easy!
Measurements: 1-1/8in (28 mm) wide x 1-1/2in (38 mm) high The groove that slides onto the bag/wallet flap has 3/16in (4mm) opening, and the lock sits about 1/2in (12 mm) high above the bag surface.
A very sturdy, high quality press lock. No key required, this is a non-locking press lock, thumb catch, tongue lock. Install this little lock by sliding the press part onto a finished bag or wallet flap and screwing through the back to secure - USE GLUE for security! Place the backing plate prongs (the catch part) through your fabric and secure over a washer. Add a layer of stabilizer in between for strength. Easy!
Measurements: 1-1/8in (28 mm) wide x 1-1/2in (38 mm) high The groove that slides onto the bag/wallet flap has 3/16in (4mm) opening, and the lock sits about 1/2in (12 mm) high above the bag surface.
A very sturdy, high quality press lock. No key required, this is a non-locking press lock, thumb catch, tongue lock. Install this little lock by sliding the press part onto a finished bag or wallet flap and screwing through the back to secure - USE GLUE for security! Place the backing plate prongs (the catch part) through your fabric and secure over a washer. Add a layer of stabilizer in between for strength. Easy!
Measurements: 1-1/8in (28 mm) wide x 1-1/2in (38 mm) high The groove that slides onto the bag/wallet flap has 3/16in (4mm) opening, and the lock sits about 1/2in (12 mm) high above the bag surface.
